Use epgu in TB3 legacy mode, epgu has no output, Although I can see my GPU in the PCI list

[AlferWu]

PLEASE READ THE FOLLOWING

• Make sure you installed the latest version of HaC Mini
• Follow all the troubleshooting steps
• Check the open issues and make sure it is not already reported
• Delete this section from your report and continue

Describe the bug
Use epgu in TB3 legacy mode, epgu has no output, Although I can see my GPU in the PCI list
(my rx590 showed driver uninstalled)

When I use the native mode the egpu works fine, but , Because I have a dual system(MAC/ Windows ), it still cannot be displayed on the system picker view, and it will only work after system fully booted.

Expected behavior
egpu work under legacy mode ,and it better to works under system picker.

Configuration

• HaC Mini version [e.g: 2.0]: 2.17
• OSX version [e.g: 10.14.6]: 11.0.1
• NUC model [e.g: NUC8i7HNK]: NUC8I7HVK
• Boot SSD model and protocol [e.g: Samsung EVO 860 1TB, SATA]: C2000PRO 1TB NVME
• Second SSD model and protocol (if installed) [e.g: HP EX920 1TB, NVMe]:
• First DIMM model [e.g: Patriot DDR4-2666 16GB]: Corsair Gaming DDR4 2400 16GB
• Second DIMM model (if installed): Corsair Gaming DDR4 2400 16GB
• Display port(s) used [e.g: USB-C, mini DP]: egpu
• Display resolution(s) [e.g: 4K, 5K]: 4k
• Any TB3 devices: Mantiz Venus eGPU
• Any USB devices: keyboard
• Any Wi-Fi/Bluetooth devices [e.g:DW1820A, BCM94360CS2, Intel 8265]: BCM94360CS2

Modifications
List any mods to config.plist, any additional kexts, anything installed to /Library/Extensions and /System/Library/Extensions, any additional patches, etc. Please attach your config.plist if you made any modifications.

Panic log
Include a screenshot of the panic message if applicable.