Output Current of Digital Pins
PeterESP8266 opened this issue · comments
PeterESP8266 commented
I`m not sure this is Issue worthy so lease delete when not:
I'm trying to power the waterproof version of the DS18b20 Temperatur Sensor via the D1 (GPIO05) Pin.
I tested the setup first by using the 3.3 Volt Out Pin and by connecting a 4.7 Resistor between VCC and the Data Pin (GPIO04) and everything worked.
Now when I'm trying the same setup but with the D1 (GPIO05) Pin instead of the 3.3 V I only get the 85 °C Error reading as if it's not properly wired.
GPI05 puts out 3.3 V when set high so that should work. I also tried the setup with different sensors like the HR-SR04 Ultrasound and the DHT-22. They all work fine.