Printing Hinges
jetcat-bob opened this issue · comments
May have answered my own question. Print exterior perimeter first, inside only.
No, that’s positioned upside down. Will fix!
Thanks!
No, that’s positioned upside down. Will fix!
hi there
Has this been corrected? What is the right orientation to print these? Struggling with print failures on them :(
It is still not correct. You will need to flip it over.
…On Thu, May 30, 2024 at 2:55 AM Ioannis Giannakas ***@***.***> wrote:
No, that’s positioned upside down. Will fix!
hi there
Has this been corrected? What is the right orientation to print these?
Struggling with print failures on them :(
—
Reply to this email directly, view it on GitHub
<#48 (comment)>,
or unsubscribe
<https://github.com/notifications/unsubscribe-auth/AYYXUORRKGEK5DJVDNM4E3DZE3ZP3AVCNFSM6AAAAABHG56HHKVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDCMZZGE4TKMJRGU>
.
You are receiving this because you authored the thread.Message ID:
***@***.***>
--
Bob Wilcox
Sorry, i re-oriented the file 27 days ago but for some reason it never pushed. Now its correct. Cherck the stealthmax wiki for latch print instructions!