Wraping
mazimazurski opened this issue · comments
Hi there!
There is a high chance that parts will wrap during printing.
My 3 attemps: in the photos, the last one with glue and brim but also not perfect.
My setup :voron 2.4 with chamber, abs Fiberlogy
I know that not only I had a problems with printing these parts.
There is no problem with wraping of v6_Cartridge_90deg - because the last layer is most critical and is finnally flat.
Do You have some print advice ?
Soome solution is to turn upside down the part V6_Plenum for printing, then last layar is also for sure flat.
