Method get_mac_address_table failed
davidh2k opened this issue · comments
davidh2k commented
We're using netbox 3.5 with the napalm Plugin. We can't fetch the mac address table (nor the lldp neighbours) for a Aruba 6100 Switch
Napalm reports the following:
{ "get_mac_address_table": { "error": "Method get_mac_address_table failed: list indices must be integers or slices, not str" }
Output from the switch itself:
SW# show mac-address-table
MAC age-time : 300 seconds
Number of MAC addresses : 366
MAC Address VLAN Type Port
--------------------------------------------------------------
b0:xx:xx:xx:xx:21 1 dynamic 1/1/51
90:xx:xx:xx:xx:cc 1 dynamic 1/1/51
0c:xx:xx:xx:xx:24 1 dynamic 1/1/51
00:xx:xx:xx:xx:96 1 dynamic 1/1/51
00:xx:xx:xx:xx:c7 1 dynamic 1/1/51
00:xx:xx:xx:xx:27 1 dynamic 1/1/51
00:xx:xx:xx:xx:08 1 dynamic 1/1/51
00:xx:xx:xx:xx:c2 1 dynamic 1/1/51
00:xx:xx:xx:xx:2a 1 dynamic 1/1/51
00:xx:xx:xx:xx:78 1 dynamic 1/1/51
00:xx:xx:xx:xx:36 1 dynamic 1/1/51
00:xx:xx:xx:xx:9b 1 dynamic 1/1/51
Version is above 10.05:
SW# show version
-----------------------------------------------------------------------------
ArubaOS-CX
(c) Copyright 2017-2023 Hewlett Packard Enterprise Development LP
-----------------------------------------------------------------------------
Version : PL.10.11.1030
Build Date : 2023-06-20 14:20:37 UTC
Build ID : ArubaOS-CX:PL.10.11.1030:c67b303ba898:202306201323
Build SHA : c67b303ba8985a29658cb8694649d2dd3454c4dc
Hot Patches :
Active Image : secondary
Service OS Version : PL.01.12.0003
BIOS Version : PL.01.0002