RPi Zero W hangs on *Starting motion eye:
ThunderClap86 opened this issue · comments
I was following the wiki and pulled the image from there. Used raspberry pi imager and fixed the first problem with the wpa_supplicant.conf, now it gets to the starting motioneye line and hangs for a couple minutes then initiates the shutdown as imaged in the attached picture.
This is a fresh install and has never been operational before. I was just hoping to have some fun with this RPi 0w, but I am stubborn and want to make this work. Can anyone help?
It is probably not the issue, but be careful when changing something via RPi Imager on any other image than official RPi OS. Probably better to use a flasher which has not even the capability to touch anything within the image file, like Rufus or balenaEtcher.
Okay, Ill try to give the image file to Rufus and see if that corrects my issue.
It is probably not the issue, but be careful when changing something via RPi Imager on any other image than official RPi OS. Probably better to use a flasher which has not even the capability to touch anything within the image file, like Rufus or balenaEtcher.
Formatted and re-imaged using unmodified file through Rufus.
Needed wpa_supplicant.conf to get past the first hangup with wired configuration. It made it to the same hang. Not sure what to try next.
I recommend dev20201026 for RPiZero
I recommend dev20201026 for RPiZero
I am re-imaging with rufus now. Ill update in a few when it's done and powered on.
I recommend dev20201026 for RPiZero
This image seems to have fixed the issue. Thank you!