Retracting instead of extruding?
AskAlice opened this issue · comments
My Inventor 1 never extrudes during prints, and when I go to filament change via the TFT display, the stepper motor first moves the filament down, tap continue, then it moves it up. I haven't messed with the wiring of the motor which worked properly on FF firmware
Hm... looks like your version of printer really use inverted logic for extruders. I already handle it with current config can you try that version with FF_DREAMER_OLD_MB
enabled ? If all be OK i will add such configuration for my regular release cycle. We already had such issue with some Dreamer printers, but never before for Inventor.
yes this fixed my issue, thanks
@moonglow can you build this for MKS?
Please read first: MKS UI GUIDE and make sure that all is connected correctly.
Firmwares:
inventor_2.0.9.3_dir_mks_.zip
can you add this variant to the release pipeline? thanks