getAddress return the first address available even if not found the device
NilsRo opened this issue · comments
I prepared 3 sensors but only 1 is connected. A call to getAddress is false but the last address found is written to the variable given.
There should be no explicit address returned if the device is not found.
Reproduction: Call a device number that is not available with at least one device connected.
milesburton/DallasTemperature@^3.11.0
Can you post a minimal sketch that shows the problem?
The image just does not give information about the content of the variables before your call.
e.g initialize the address with all 0xFF before any call.
Attached a simple sketch.
Output with one DS18B20 connected:
ets Jun 8 2016 00:22:57
rst:0x1 (POWERON_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)
flash read err, 1000
ets_main.c 371
ets Jun 8 2016 00:22:57
rst:0x10 (RTCWDT_RTC_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)
configsip: 0, SPIWP:0xee
clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00
mode:DIO, clock div:1
load:0x3fff0030,len:1344
load:0x40078000,len:13864
load:0x40080400,len:3608
entry 0x400805f0
289D8F16A8013C7A
289D8F16A8013C7A
Output with no DS18B20 connected:
rst:0x10 (RTCWDT_RTC_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)
configsip: 0, SPIWP:0xee
clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00
mode:DIO, clock div:1
load:0x3fff0030,len:1344
load:0x40078000,len:13864
load:0x40080400,len:3608
entry 0x400805f0
0000000000000000
0000000000000000
Expected result in first example would be:
289D8F16A8013C7A
0000000000000000