Schematic ou gerber file
greentocic999 opened this issue · comments
Hi Everyone, i need to get a schematic ou gerber file of the mks-dlc32 V1.1 (LS ESP32 PRO V1.1).
Grateful
@greentocic999 - did you have success for the file? Currently i'm looking for a shematic of the PCB. Do you have any documents?
I was unsuccessful, in fact. But what is your question, I can try to help you
…________________________________
De: Alex ***@***.***>
Enviado: quinta-feira, 11 de abril de 2024 16:04
Para: makerbase-mks/MKS-DLC32 ***@***.***>
Cc: greentocic999 ***@***.***>; Mention ***@***.***>
Assunto: Re: [makerbase-mks/MKS-DLC32] Schematic ou gerber file (Issue #469)
@greentocic999<https://github.com/greentocic999> - did you have success for the file? Currently i'm looking for a shematic of the PCB. Do you have any documents?
—
Reply to this email directly, view it on GitHub<#469 (comment)>, or unsubscribe<https://github.com/notifications/unsubscribe-auth/AVUXCYX6H7X44GH5QY5PGATY43NC5AVCNFSM6AAAAABFQQRKL2VHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDANJQGMZTGMBWG4>.
You are receiving this because you were mentioned.Message ID: ***@***.***>
I try to install a Limit switch for Z, as the pcb has a connector for it.
On the custom configuration in fluidnc i can select a (gpio) port, which the limit switch is connected to.
I don't know which port to chose...
Also tried to measure/trace the signal pin on the pcb to the esp, without success.
What's the version of your pcb?
It's LS ESP32 V1.0
i thing about going on a MKS LS ESP32 PRO, any recommendations?