MKS DLC 32 Limit Switch connection
esloch10 opened this issue · comments
Hello,
I'm seeking guidance on connecting a limit switch to the MKS DLC32 board and would appreciate your assistance with the correct procedure.
Initially, my plan was to use a simple two-wire switch, which I believe should function adequately. However, my research indicates that the MKS DLC32 board is designed for limit switch modules with three wires.
Considering I hadn't initially planned for modules, I'm contemplating a DIY solution based on a diagram I found. However, I'm unsure of its accuracy and would appreciate your insights.
Additionally, I intended to integrate an emergency stop button into my setup but haven't identified a dedicated connector for it. What course of action would you recommend?
Thank you for your assistance.
S pin connect to common limit switch
G pin connect to normally open
thanks