Is the gerber file good to go?
FovenX3 opened this issue · comments
I didn't find hdmi and csi interface in gerver file like the 3d render picture you provide in readme. May I have a gerver file and BOM that I can make this io bord directly? Thankyou!
Hi,
You didn't find the 3D models for HDMI,CSI and the CM4 in the repository
because Github has a limit on max file size of each file that you can
upload.
Thus, I cannot upload 3D models without compressing them into zip files
which you have to manually decompress and then add to KiCAD to each
component.
As far as the gerber and BOM, there are a few things missing like the I2C
bus for the HDMI outputs are not yet routed in the uploaded version and few
other things that are not yet complete.
Due to some work I got busy and left this project in its current state,
Although I did fix things but hadn't had the time to push updates to the
repo.
If you want to build this now, You will need to fix the issues. You can get
the component names from the netlist/schematic for the BOM.
I will try to fix the problems as soon as possible as I get some free time.
…On Fri, Feb 5, 2021 at 3:00 PM zxwanghongyi ***@***.***> wrote:
I didn't find hdmi and csi interface in gerver file like the 3d render
picture you provide in readme. May I have a gerver file and BOM that I can
make this io bord directly? Thankyou!
—
You are receiving this because you are subscribed to this thread.
Reply to this email directly, view it on GitHub
<#1>, or unsubscribe
<https://github.com/notifications/unsubscribe-auth/AE6DS6GIBXDXZN6DAITSGHDS5O3FHANCNFSM4XENWMPA>
.