document how SWFWire must be run
drzraf opened this issue · comments
After cloning there is not hint about where/what the program entry point is.
Using a command-line based GNU/Linux distribution, what are the step the run the program?
And how compatible is it with gnash/lightspark/swfdec/...?
Open one of the sub-folders as a project in Flash Builder.
It's a lot easier to build with Flash Builder, but it can be done on the command line.
It should be something like this, assuming mxmlc is already setup:
mxmlc -load-config SWFWireDebugger\config.xml