Beast code in Giters

kof999's repositories

x-tools

Qt SerialPort-UDP-TCP-WebSocket-Modbus-CAN-BLE-Assistant.

LGPL-3.0000

IMSProg

IMSProg - Linux IMSProg - I2C, SPI and MicroWire EEPROM/Flash chip programmer for CH341a devices.

GPL-3.0000

SNANDer

SNANDer - Serial Nor/nAND/Eeprom programmeR (based on CH341A)

GPL-2.0000

CH341a_spi_programmer

QT5 programmer software for the readind/writing SPI NOR FLASH use the CH341a device.

GPL-3.0000

stm32-vserprog

flashrom serprog programmer based on STM32 MCU & USB CDC protocol. Uses libopencm3 and deprecates the old serprog-stm32vcp project.

GPL-3.0000

ch341eeprom

A libusb based programming tool for 24Cxx serial EEPROMs using the WinChipHead CH341A IC

GPL-3.0000

This project enables you to monitor and control a Daikin hybrid heat pump and various other (Altherma) models as a bridge between MQTT(wifi) and the 2-wire P1/P2 controller wires using an ATmega328P, ESP12F, and some electronics.The P1P2Serial library and P1P2Monitor program enable low-level reading and writing of the P1/P2 bus and parameter interpretation and control. The P1P2Serial library may also be used for other Japanese Home Bus System based standards: DIII-NET (F1/F2) bus, Mitsubishi M-Net bus, Toshiba TCC-Link, Hitachi H-link, Panasonic/Sanyo SIII-Net, Haier, York, ..

GPL-2.0100