[BUG ]4Max Pro - After use M0, resume is possible only from command prompt
Jaroslaw75 opened this issue · comments
Hallo,
I'm not sure is it a bug or my foult.
I'm using M0 to pause print and insert the nut, after that printer stopping, but resume is possible only from command prompt (if PC is connected I can send M108)
According to Marlin M0 spec. LCD should display message to confirm and unpause machine.
Yes, this is a bug. You can try M600 to pause the print, but it seems that there is an issue with the old Anycubic tft. I'll take a look!
The M600 works, I can resume from the LCD, unfortunately, after using the M600, the printer automatically removes the filament. This is a little bit problematic.
You can use parameters on M600 for custom filament unload/load length. Alternatively you can configure your M600 with M603. See https://marlinfw.org/docs/gcode/M603.html.
Maybe this could be a workaround for you?
Thanks for the tip, I'll test it.