Octoprint's command bar always jumps down
kroehrer opened this issue · comments
Hello, I have the FLsun Q5 and am trying to calibrate the extruder and change the rod length and carriage offset. Only with this printer does the right bar jump in the Octoprint. If I enter M205, the values come up, but if I want to scroll up ,the data jumps down again immediately.What can I do?
What do you mean, the console window in the right?
When you send a command via console and the printer prompt a message back to Pronterface then this will be shown in the console window at the last line. Scrolling down is the wanted behavior in the console window.
When you are scrolling up and the printer sends a new message to the console window the behavior is that the cursor will immediately jump to the last line where the newest message is shown.
Edit: I forgot to mention that you can set via -->Settings -->Don't autoscroll in case you don't want this behavior.
@kroehrer,
Did you solve your issue?
Best regards,
DD
No feedback.
@rockstorm101, guess, we can close the issue.
No feedback. @rockstorm101, guess, we can close the issue.
Agreed, thanks. Closing.