scan stop
dariushabbasi opened this issue · comments
I am following to connect two of them to each other . AT+HOSTEN1 AT+RST AT+SCAN1 but after a short time i recived +scan stop
i connected it via TTL to serial port and just sending AT commands and nothing else in hardware I have done unless that connecting power
What scheme did you connect and what target did you want to get?
If you work with AT-commands, then you need to turn on the AT-mode, for this you need to hardware connect a pin P00
Look it this document by hardware connect:
https://github.com/kichMan/JDY-08/blob/master/KiCAD/datasheet.pdf
Thank you KichMan for your reply
I really apologize you for asking this kind of question here.
AT commands are replying as I told , so I do not think I p00 is my point of mistake , it is disconnected now and many AT commands have reply.
my point is : after two At commands( AT+HOSTEN1 AT+RST) reply OK .
AT+SCAN1 at first reply Ok also after a while it send to me +scan stop
actually when I connect POO to GND the AT COMMANDS dos not response at all but when ever I let it be disconnected to connect it yo 3.3v the AT commands are replying except that AT+SCAN1 which reply +OK+SCAN:STOP
Just now I have found that AT+ADVEN1 replied to be +ERR:1002
I do not know why ? but I am sure the first of all I have to fix it .
could you please help me in this matter ?