Tab support unecessary
kennetek opened this issue · comments
I would hate to see the support go away on the tab. I get that everything
perfect it's unnecessary. I could get behind a toggle that perhaps turned
it off or on, but me personally, even though my printer is in good shape, I
still use it as little as possible...
…On Fri, Mar 17, 2023 at 11:05 AM Kenneth ***@***.***> wrote:
Tabs can be entirely flat underneath if your printer's bridging is good.
See #73
<#73>.
—
Reply to this email directly, view it on GitHub
<#86>, or
unsubscribe
<https://github.com/notifications/unsubscribe-auth/AJZT3EJXF7NRH7WLKOZDCALW4SRYJANCNFSM6AAAAAAV62ZWGM>
.
You are receiving this because you are subscribed to this thread.Message
ID: ***@***.***>
Do not worry! It would be a toggle. All new features are always a choice, the base bins will always stay the same.
If you set a_tab=10 you essentially get this result already.