irshad ahmad's repositories
4_Axis_SPI_CNC
4 Axis CNC Controller for Grbl_ESP32
Blynk-4-Channel-Relay-Status-Sync-with-Physical-Button
Blynk: 4 channel relay status sync with Blynk app, Relay and with Physical button/Switch/Push button. If you perform ON/OFF with Physical Switch/Push button switch it lets you change the ON/OFF status on Blynk app as well.
CNC_Breakout_Nucleo64
CNC breakout for STM324F411 and ST32F446 development boards
Configurations
Configurations for Marlin Firmware
E4d-box-project
E4d@box-project
ESP32-Reflow-Controller
Reflow controller with ESP32 and TFT LCD on board.
ESP32-RGB64x32MatrixPanel-I2S-DMA
An experimental Adafruit GFX Compatible Library for ESP32 and HUB75 RGB LED Panels. Using DMA to drive the panel for higher refresh rates.
esp32_ili9341
LittlevGL ported to ESP32 using ILI9341 display controller
ESP32_Plotter_Controller
An ESP32/TMC2130 based 2 axis controller designed for pen plotters
FreeCAD-library
A library of Parts for FreeCAD. WARNING - This library is huge. It might take a long time to download and make the addons manager unresponsive for many minutes.
HASS-sonoff-ewelink
Home Assistant component to control Sonoff/eWeLink devices with original firmware
LDmicro
This is LDmicro support repository
Morpheus-STM32
A small 3D printer controller board for use with a "blue pill" STM32F1 generic board. Inspired on http://reprap.org/wiki/SinapTec
MPCNC-TFT35-V2.0
Custom firmware for the BigTreeTech TFT35 V2.0 for use with the MPCNC
nanoReflowController
Reflow Oven Controller. See below for more information.
NCMate
Fluid-NC Motion Controller Hardware
Power-Boards
Collection of DC/DC Converters, Battery Chargers and Power Supplies
sonoff_registered_devices
List all registered devices using eWelink
SuperGerbil
STM32 driven ARM Grbl firmware
wirebender
Precise wire bending CNC machine for wires at 1mm and less in diameter.