Instructions out of order

[Max Wofford]

I just went through and built a blot from one of the demo kits in the office.

There's an instruction to add a nut to a nut trap in the Printed Rail component:

The nut isn't referenced again until Final Assembly, 2 chapters later:

In between the steps, the nut fell out of the trap multiple times:

I'd suggest adding the nut trap, and adding the belt bearing assembly in the Printed Rail component chapter, then only needing to add the belt during final assembly.

[leomcelroy]

I agree with reordering this.

[leomcelroy]

Corrected on new assembly guide.