Raspberry PI B +
ChrisCalzaretta opened this issue · comments
Using win 32 disk image and the 9.0 minera image. The Pi will not boot. The pi just stays at the colored screen and do not move forward.
I have had this installed and running on a Pi B 2015 model version 1.2 for almost 7 months or so.
I have tried the image twice, not to say i am not doing something wrong but it is very easy to get it up and running
I am going to try the manual way to get this up and running on the Pi B+
As a daily linux user and IT guy, i would first check that the image is correctly on the SD card:
If you have access to a Linux Desktop, you could try to put the SD-Card into a reader, and check if you can access the main system partition, and if there is a separate one for the boot partition, also that.
Also you could try to reimage the SD card from the Linux desktop too with
dd bs=4M if=minera-latest.img of=/dev/your-sd-card
And I know it is maybe a too a basic question, but you remembered to uncompress the zip file before trying to flash it, right?
What's the version in B+ you pull out?
I second this. The .9 image produces a colored screen but does not actually load the OS.
If you see here https://getminera.com/ there are more than 3 thousands Minera 0.9.0 running, so your problem must be with some specific configuration/hardware/dontknow you have.
Impossible for me to understand it without more informations.
The number running has no correlation to the problem at hand.
https://www.adafruit.com/product/3775?gclid=EAIaIQobChMIrZ2UhN342gIVyIqzCh3y9QrxEAQYASABEgLEivD_BwE
It’s the newest version of the Pi. OOB configuration. No changes. I just installed raspian and installed it manually because the image isn’t compatible.
Raspberry pi B version 1.2 and below the .9 image seems to work
Rapsberry pi B+ which is the link jwb6658 supplied the .9 image does not work
https://www.adafruit.com/product/3775?gclid=EAIaIQobChMIrZ2UhN342gIVyIqzCh3y9QrxEAQYASABEgLEivD_BwE
I will buy a Rpi 3 B+
I can confirm with a 3B+ that I had the same block color image when I boot up. I figured out the issue is with the start.elf files.
- Write the image file as directed
- After the image is written open the drive listed as boot
- Rename the old start.elf files to start_old.elf etc...
- Copy either the start.elf files I have attached here or from a most recent Raspian image.
Should work fine now. Someone let me know if this works for them also. I spent all day on figuring this one out.
Hello,
the file works perfectly,
however, I have a problem,
my rspberry has no IP address or is not detected by my internet box,
an idea?
Ok it works
Now i want to enable my wifi on rspb pi3 b +
iwconfig : eth0 and lo : no wirless extention
Can I activate my wifi?
v0.9.1 should work out-of-box with RPI B+
For wifi check sudo wicd-curses