stuck at STATE 0

Question

stuck at STATE 0

RadioMan57 opened this issue a year ago · comments

Running your sketch in VS Code. All libs in place, no build errors. Execution stops at STATE 0:

rst:0x1 (POWERON_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)
configsip: 0, SPIWP:0xee
clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00
mode:DIO, clock div:2
load:0x3fff0018,len:4
load:0x3fff001c,len:1044
load:0x40078000,len:8896
load:0x40080400,len:5828
entry 0x400806ac
Connected to Serial
AXP192 Begin PASS
All comms started

===== STATE 0

Any ideas?

erythana · Answer 1 · Fri Dec 15 2023 23:21:27 GMT+0800 (China Standard Time)

Did you find a solution for this?

RadioMan57 · Answer 2 · Fri Dec 15 2023 23:46:02 GMT+0800 (China Standard Time)

Unfortunately not. Have ordered some spare parts, so I simply scrapped this one.

erythana · Answer 3 · Fri Dec 15 2023 23:58:37 GMT+0800 (China Standard Time)

I did just find one in this very moment:
Downgrade the Sparkfun GNSS library to 1.7.2 and then get to a outdoor place

RadioMan57 · Answer 4 · Sat Dec 16 2023 01:50:31 GMT+0800 (China Standard Time)

Thanks! Good to know in case another device will show similar symptoms.