Cloning Klipper from https://github.com/Klipper3d/klipper : failed!
fabse-hack opened this issue · comments
Linux Distribution
MainSail OS
What happened
kiauh Klipper uninstall / install - install failed
What did you expect to happen
How to reproduce
install klipper ...
Additional information
i try to install klipper with kiauh:
why i get this error?
// i think it is a git problem, buffersize or something, i change it already and go to http1.1, still error
// purge git and install git with kiauh brings a new error:
fatal: unable to access 'https://github.com/Klipper3d/klipper/': GnuTLS recv error (-110): The TLS connection was non-properly terminated.
###### Checking for the following dependencies:
● git
[✓ OK] Dependencies already met!
###### Cloning Klipper from https://github.com/Klipper3d/klipper ...
Cloning into '/home/pi/klipper'...
remote: Enumerating objects: 60994, done.
remote: Counting objects: 100% (47/47), done.
remote: Compressing objects: 100% (34/34), done.
error: RPC failed; curl 92 HTTP/2 stream 0 was not closed cleanly: CANCEL (err 8)
error: 4450 bytes of body are still expected
fetch-pack: unexpected disconnect while reading sideband packet
fatal: early EOF
fatal: index-pack failed
#=======================================================#
Cloning Klipper from
https://github.com/Klipper3d/klipper
failed!
#=======================================================#
pi@mainsailos:~ $
So... what should I do, if even you yourself think it is a git problem?
i'm not understand this error.
When i do sudo git clone: https://github.com/Klipper3d/klipper/ then it's working...
you usually do not use sudo to clone anything.