DPrime's repositories
3DPrinterScreen
ESP32 based touch screen 3d printer controller
5-axis-3D-printer
Slicing Algorithm based on Skeleton for pipe-like components
BIGTREETECH-SKR-PRO-V1.1
Aiming at some problems existing in 3D printed motherboards in the market. Bigtree Technology Co., Ltd. launched a high performance 3D printer master board with STM32F407ZGT6 as the core controller, BIGTREETECH-SKR-PRO-V1.1.
BIGTREETECH-TouchScreenFirmware
support TFT35 V1.0/V1.1/V1.2/V2.0/V3.0, TFT28, TFT24 V1.1
esp32_pendant_marlin
This Marlin v1.9 pendant was made using micropython to control an Marlin board (tested on the Arduino MEGA2560 + RAMPS V1.4) the ESP32 uses Serial Port 2 to communicate with the RAMPS aux port.
ESP_Pilot
ESP32 Flight Controller for quadcopters
FullControl-GCode-Designer
Software for designing GCODE for 3D printing
grbl_6axis_on_stm32
grbl_6axis_on_stm32
GUIslice
GUIslice drag & drop embedded GUI in C for touchscreen TFT on Arduino, Raspberry Pi, ARM, ESP8266 / ESP32 / M5stack using Adafruit-GFX / TFT_eSPI / UTFT / SDL
MovementGameController
Wireless movement based game controller. Interfaces a joystick, buttons, 9 DOF IMU, and an ESP8266 WiFi MCU dev board. Programmed with Arduino.
MRR_ESPA
A basic 3D printer control board based on ESP32
nrf24_multipro
nRF24L01 multi-protocol RC transmitter
quadF
Quadcopter project using ESP32 as flight controller and GY86 as 10DOF (MPU6050 as accl/gyro, hmc5883l as magnetometer and the best of all MS5611 as barometer for height ofcourse)
RC_RX_CABELL_V3_FHSS
RC Reciever firmware using arduino and NRF24L01+
RealtimePi
An out-of-the-box raspebrrypi/raspbian distro with a realtime kernel
sscara
Small size 3d printer with SCARA based mechanics
WIFI-CONTROLLED-DRONE-V4
DRONE BASED ON NODEMCU
Z-probe-on-smd-resistors-2512
Auto bed level strain gage for 3D printer using resistors 2512 instead of strain gauges.