Calibration / offset
bipsendk opened this issue · comments
bipsendk commented
Is there some way to configure an offset or calibrate a flashed device ?
I have a device that seems to always show a humidity 9% higher than other references.
I know, that I can put an offset value into Z2M - but this only helps on values exposed to e.g. HomeAssistant via MQTT .. It would be nice if the display value of the device actually also was correct..
Victor commented
Today this is only possible for another beta firmware version.
The same is true for the option with simultaneous operation of Zigbee and BLE.
Ivan Belokobylskiy commented
It is supported starting from version 1.1.0.