Battery percentage bug
kb79000 opened this issue · comments
Hello until today no particular problem but there I have a bug on the battery percentage do you know if it is my battery which is already showing signs of weakness or a potential firmware bug ?
Link video : https://drive.google.com/file/d/1JFOYwya3aSmJ9MoAeftybh92t1_GjRX4/view?usp=drivesdk
Thx
BBS02? Probably same as #114, no solution has been found but workaround for the more severe issues (power cut) was implemented.
The problem appeared today without change but the worst is that the motor does not always send the power requested via the accelerator there are also cuts while pedaling battery problem controller firmware? 😭
Might be something else then, which version are you on?
Might be something else then, which version are you on?
I'm on version 1.4 I had put a restriction to limit the heating and today it's much cooler than the last time I tested it, I'll put back the original configuration and I hope everything will go back in order 🤒
I put the original 1.4 back and I have the same problem when I start the maximum power about 1100 watts from the throttle it delivers the power I leave it on for about 30 seconds I cut it and go back on the throttle there has more than 150 watts or almost nothing, I restart the screen the maximum power is available again and the problem reappears. There is also sometimes no power coming on the pas mode I am lost .... can error codes like the original bafang firmware also appear on this firmware? Thank you for your feedback.
Most error codes are implemented but not all I think. Sounds a bit like you are hitting low voltage ramp down but that doesn't entirely fit your description of the problem either. I guess you should try flashing the original firmware
La plupart des codes d'erreur sont implémentés mais pas tous je pense. On dirait que vous frappez une rampe de basse tension, mais cela ne correspond pas non plus entièrement à votre description du problème. Je suppose que vous devriez essayer de flasher le firmware d'origine
Yes maybe I should go back to the original firmware to see if an error code appears there is a wiki for the return to the original firmware?
Unfortunately same problem with original bafang firmware and no error code, intermittent power cuts another video : https://youtu.be/qPjzufPbuAI
😢
I'm just giving you a feedback my problem came from a heating point between the battery connector and the support on the negative pole :
https://rehost.diberie.com/Picture/Get/f/202115