Unable to burn firmware for esp8285
zhuwei opened this issue · comments
I detected that the voltage of 3.3V was normal, and pwm1 was also connected to GND.
How else do I need to test?
During power-up, the ESP's boot pin must be pulled high or low (can't look it up because I'm on vacation). You can do that with a female-female cable on the servo header. Look up the boot pin in the schematic to see which pwm output that is
I tested it with a multimeter,boot pin has be pulled low, and TX and Rx are also the same as pwm2 and 3.
But I made three, but I still can't burn them.
sorry, I'm ready to give up
Don't give up! Are you on the elrs discord? There we can help in a much more interactive manner