DW.miniESP Firmware Support
This is official page of software support from Deaware.
Special thank.
- Adafruit.
- ESP8266 forum.
Board information
- VCC is 3.3V
- All gpio is 3.3V
- 10 bits ADC is 0 - 1V.
- VIN is 4.5V - 12V.
How to use DW.miniESP with Arduino IDE (version >= 1.6.4)
1) Connect the USB to Serial to DW.miniESP
- Directly plug USB to Serial to DW.miniESP. (Only for 6 Pin USB to Serial Arduino Programmer)
- Wiring USB2Serial to DW.miniESP following this table. (Any USB to Serial)
| USB to Serial | DW.miniESP |
|---|---|
| GND | GND |
| VCC | VCC |
| TXD | RXD |
| RXD | TXD |
2) Preparing Arudino IDE (version >= 1.6.4)
- If you don't have Arduino IDE (version >= 1.6.4) or you have Arduino IDE version < 1.6.4, you can download directly from this link
- Firstly, Add Board Manager URLs by goto File > Preferences and fill Add Board Manager URLs with the following link.
http://github.com/deaware/dwcloud_firmware_support/raw/master/package_deaware_index.json
- Open "Boards Manager" by goto Tools > Board > Boards Manager...
- Select ESP8266 by Deaware and click Install.
- Check ESP8266 is available by goto Tools > Board and you will see DW.miniESP.
3) Uploading program to DW.miniESP
- Preparing your code.
- Confirm that your setting is correct.
- Reset your DW.miniESP into PROG Mode by set the PROG/RUN switch to PROG Mode position like the picture below and press RESET.
- Press upload button to upload.
