Plus quad not supported in viewer
lazd opened this issue · comments
I recently got some logs tearing around in my Mitsuko and found there is no way to change the visualization from a X quad to a + quad. This would be helpful in visualizing how much the rear motor is working to providing forward thrust.
It's clear the rear motor (1 on the + quad) corresponds to the back left motor (1 on the X quad), of course, but it would be nice if the visualization matched the data.
I have a similar issue with tuning my airplane & flying wing, the blackbox view shows it as a quad motor.
Would like to see servo values rendered on an airplane airframe. This graph shows me nothing about what the servo's are doing.
The 2D Craft & 3D Carft files need to be modified to add additional aircraft models. But before that, the Blackbox viewer needs a way to know what type of craft the blackbox data is from.
Could the flight controller report the aircraft configuration in the blackbox data?
If the flight controller can report the aircraft configuration then the viewer can use that to determine it and render the correct model. Could use a FlightLogEvent at the start of each logging session.