(Reopen) GUI does not scroll correctly until Rescan button pressed.

[Google Code Exporter]

Still scrolls incorrectly for me - just tested it.

** New info: Hitting the rescan button makes the scrolling behave
correctly.  It still does not scroll correctly on first entering the app. 
The rescan workaround is good enough for me.

Running on firmware 1.0.2.  Using version 0.04.1189413695 installed via
AppTapp Installer.  Launching the app via SummerBoard.

I have 13 wifi networks in my immediate area.  3 are open and 10 protected.
 When I open Stumbler, the 3 networks are shown in the top under the "Open"
header.  The "Protected" header shows underneath with the first three
networks in that group.

If I flick the screen upward, it scrolls into the Protected group, but then
immediate springs back down so that half of the "Open" header is showing
(with no entries) with the "Protected" header and its entries immediately
below it.

Dragging the screen upward gives a similar result - as soon as I release
the screen, it immediately springs back down so that the "Open" header is
partially showing.

Because of this behavior, I can only see the first 6 protected networks
unless I hit rescan.

Original issue reported on code.google.com by [e-mail] on 21 Sep 2007 at 8:51

[Google Code Exporter]

Ok, definately sounds like a code bug - I usually don't get any networks on 
first
entering the app, so I didn't notice it.
For now, rescan is the recommended resolution, however the next version should 
have
this fixed.

Thanks

Original comment by [e-mail] on 21 Sep 2007 at 8:56

• Changed state: Started
• Added labels: Priority-High
• Removed labels: Priority-Medium

[Google Code Exporter]

Yes, and only a cosmetic bug at that.  Good work on this app!

Original comment by [e-mail] on 21 Sep 2007 at 9:01

[Google Code Exporter]

Confirmed on 1.1.4.  Last protected network on the list springs back beneath the
visible area after scrolling to the bottom.

Original comment by [e-mail] on 27 May 2008 at 10:00