Some problem with serial communication

[Regressor]

Hi. I got a ultimaker2 to repair. It got a hole inside X-driver and then 24V inside 5V line and all 5v related chips was burned.

So I replaced drivers, cpu, usb and others and start to test it. I downloaded Marlin3DprinterTool, send some $ for beer, got license, pressed connect and then I realized that there is no communication with printer at all. There is can be single RX led flash once and then nothing (RX/TX leds on board are OFF). Show communication window is empty.

When I connects to serial port with putty or another tool and press keys I can see RX led flashing on printer pcb. I need this tool to test and calibrate all printer systems.
So what I'm doing wrong ?

I'm using windows 7.

[Johnny Lindén]

Hi, There can be an issue with M503 command. Try on the initial screen to press button M503 and see if the M503 = read current settings will wake up the communication. Also be sure that no other software has stolen the COMx port. If you run Cura/Simplify3D it will establish communication and M3DpT will not be allowed to use the COMx port. Regards Den fre 10 dec. 2021 kl 14:09 skrev Regressor ***@***.***>:

…

Hi. I got a ultimaker2 to repair. It got a hole inside X-driver and then 24V inside 5V line and all 5v related chips was burned. So I replaced drivers, cpu, usb and others and start to test it. I downloaded Marlin3DprinterTool, send some $ for beer, got license, pressed connect and then I realized that there is no communication with printer at all. There is can be single RX led flash once and then nothing (RX/TX leds on board are OFF). Show communication window is empty. When I connects to serial port with putty or another tool and press keys I can see RX led flashing on printer pcb. I need this tool to test and calibrate all printer systems. So what I'm doing wrong ? I'm using windows 7. — You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub <#180>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AAFOEYKIA7NYU4TL6JOKZUTUQH32HANCNFSM5JZDGDCA> . Triage notifications on the go with GitHub Mobile for iOS <https://apps.apple.com/app/apple-store/id1477376905?ct=notification-email&mt=8&pt=524675> or Android <https://play.google.com/store/apps/details?id=com.github.android&referrer=utm_campaign%3Dnotification-email%26utm_medium%3Demail%26utm_source%3Dgithub>.

[Regressor]

Thank you. Yes. It was because of unfunctional printer firmware, I reflashed it and now Marlin3DprinterTool works good. I have some strange issue with xyz end switches (when I press x,y,z switches Marlin3DprinterTool allways lights minX + maxY + maxZ cirlces in endstop tab). I checked them using pronterface and they works ok - all axes stops with correct log message).

P.S. Is there any way to blowing separate check?