The two black JST-SH connectors don't have a retention bed, unlike the white JST-SH connectors

Question

The two black JST-SH connectors don't have a retention bed, unlike the white JST-SH connectors

dorovl opened this issue 6 years ago · comments

Vlad-Andrei Dorobantu commented 6 years ago

The connector that plugs inside is not retained. By vibrations, this connector comes out and this is particularly dangerous in the context of a flight controller (our project).

Therefore we recommend to put also a white JST-SH connectors on the next version.

David · Answer 1 · Mon Dec 09 2019 23:27:40 GMT+0800 (China Standard Time)

I have had a problem with the white plastic housings on the motor drivers pulling right off the board when we pull a plug out. They are not JST-SH, I can't recall the spec.

Vlad-Andrei Dorobantu · Answer 2 · Mon Dec 09 2019 23:43:04 GMT+0800 (China Standard Time)

Please note I'm speaking about the "Power out" and "4 ADC" connectors (see red arrow) :

I also had the problem with the plastic housings of the motor drivers pulling right off the board when I pulled out a plug, but maybe you might open another issue for this?

Vlad-Andrei Dorobantu · Answer 3 · Tue Dec 10 2019 19:12:45 GMT+0800 (China Standard Time)

Closed, because it was submitted on upstream git repository (jadonk/beaglebone-blue) instead.

Jason Kridner · Answer 4 · Wed Jun 10 2020 01:04:11 GMT+0800 (China Standard Time)

Let's keep the issues here.