wraith multi_capture command not working
spencer95 opened this issue · comments
When calling:
wraith multi_capture /vagrant/paths-en/nodes1.yml /vagrant/paths-en/nodes2.yml
I get the error message:
ERROR: "wraith multi_capture" was called with arguments ["/vagrant/paths-en/nodes1.yml", "/vagrant/paths-en/nodes2.yml"]
It may be that I have the wrong format for the file list, but I can't see anywhere that specifies the file list format.
Issue checklist:
-
[Yes ] I have validated my config file against YAML Validator to make sure it is valid YAML.
-
I have run the
wraith info
command and pasted the output below:
DEBUG: #################################################
DEBUG: Command run: info
DEBUG: Wraith version: 4.2.3
DEBUG: Ruby version: ruby 2.5.1p57 (2018-03-29 revision 63029) [x86_64-linux-gnu]
DEBUG: ImageMagick: Version: ImageMagick 6.9.7-4 Q16 x86_64 20170114 http://www.imagemagick.org
DEBUG: PhantomJS version: PhantomJS not installed
DEBUG: chromedriver version: ChromeDriver 76.0.3809.126 (d80a294506b4c9d18015e755cee48f953ddc3f2f-refs/branch-heads/3809@{#1024})
DEBUG: CasperJS version: CasperJS not installed
DEBUG: #################################################
Connection to 127.0.0.1 closed.
- [ Yes] I have run the command in verbose mode (by adding `verbose: true` to my config) and pasted the output below:
ERROR: "wraith multi_capture" was called with arguments ["/vagrant/paths-en/nodes1.yml", "/vagrant/paths-en/nodes2.yml"]
Usage: "wraith multi_capture [filelist]"
Connection to 127.0.0.1 closed.
- I have pasted the contents of my config file below:
The config files work fine when wraith capture is run on them individually.