Giters

arsi-apli / BLDC_Klipper_doc

This is documentation for a modified version of the Klipper firmware that allows you to directly drive a BLDC Motor in an open loop configuration instead of a stepper motor.

Geek Repo:Geek Repo

Github PK Tool:Github PK Tool

bldcklipper3d-printing

Documentation for BLDC Motor support for Klipper firmware

Supported boards:

  • Arduino UNO - Hardcoded pins, one bldc motor
  • STM32F401 NUCLEO - fully customizable pin configuration, up to three motors, holding power
  • Raspberry Pi Pico - fully customizable pin configuration, holding power

The documentation can be found here

About

This is documentation for a modified version of the Klipper firmware that allows you to directly drive a BLDC Motor in an open loop configuration instead of a stepper motor.

bldcklipper3d-printing

Languages

Language:Shell 100.0%