Single piece skirts
dmason1992 opened this issue · comments
Is your feature request related to a problem? Please describe.
Single piece skirt would be stronger for the table than the two piece one.
Describe the solution you'd like
Add option of single piece skirt for those with large enough printers.
Describe alternatives you've considered
Some form of mechanical joint between the two half width skirts to add the same support
Additional context
N/A
Corrected the heatset depth holes for the M5 inserts that go in the bolt down brackets to fit the LDO supplied inserts.
Changed from sacrificial bridges to "cross bridge" on the bolt down bracket M5 bolt holes.
Cleaned up some fillets on the rear skirt.
Combined front and rear skirts into one piece each.
Milo_Skirts_1piece.zip
Adding LDO modified one piece rear skirt. Corrected power inlet tab locations.
Rear_Skirt_LDO_1pc.zip