CC1101 does not receive or transmit anything

[VIKVIXX]

I bought TI-CC1101 and used it with arduino uno to sniff but when i uploaded any code from SmartRC library only thing i get on serial monitor is "Connection OK" i tried already like 6 RF remotes with 433.92 MHz but nothing happened so i bought same but new CC1101 module i also bought arduino mega and logical converter and after was everything was connected and i upload code it said "connection error" but without converter it said again "Connection OK" but still doesnt recieve or transmit anything. what should i do?

[0x5c4r3]

So, in my experience, I am using an ESP32 with a CC1101. I am able to transmit without problems, but when I try to receive a signal sent from a cheap Radio doorbell transmitting at 433.92 MHz, nothing is detected. Don't know if it's a protocol problem or anything else.

[VIKVIXX]

I tried using my garage door remote
Other garage remote
house alarm remote
And relay RF remote but not a single one was captured

[zillawilli]

Hello
I have the same configuration as you (Nano and CC1101) and the same problem.
It was not able to read the line "Tx Mode" in the serial monitor.
Best regards

[frspp]

Same here - does not receive anything.

Nodemcu ESP32 (ESP32-D0WDQ6) https://www.berrybase.de/esp32-nodemcu-development-board
TI CC1101 https://www.makershop.de/module/funk/cc1101-433mhz/

[esr]

Same here, esp32 s3.