ArmStone

as_bringup

Contains the as1 and as2 launch files. The two files are intended to be launched on the two intel nucs.

as1 connects to the motors
as1 launches the control stack ( motors and arm)
as2 runs localisation, connects to lidars etc
Dont forget udev rules on as1. See as_bringup/config/udev. The devices are named, so its important its all setup

as_control

Remember to initialise mecanum drive controller and vesc driver submodules
hardware interface is setup so that it merges the motor and arm hw interfaces into a combined one.

as_description

Pretty modular urdf setup
robots folder contains all the entry points
Otherwise I recommend just looking through how components are setup by reading the urdf folder contents.

as_localisation

has some launch files for slam_toolbox and some residue from experimenting with end-effector held realsense l515

as_xarm

stores the submodule for xarm drivers

Original software setup

Wifi Armstone5G
- armstone@ArmStone1 (192.168.1.101)
- armstone@ArmStone2 (192.168.1.102)
OS on nucs is u20
docker container runs ubuntu 18 (for running ros melodic)
DC control box IP 192.168.1.212 (For use with xarm studio)
Setup Sofware
- Start the docker container and open shell into it
- git clone https://github.com/JuliusSustarevas/ArmStone.git
- git submodule update --recursive
- git submodule update --init --recursive
- (in ~/armstone) catkin build
- (in ~/armstone) source devel/setup.bash
- ... Things are already setup till here in the ~/armstone folder
- edit as_bringup as1.launch to enable the controls/modes you want
  - Remember to turn arm on/off
- roslaunch as_bringup as1.launch

xARM

Note that xarm payload is calibrated for Armstone Extruder and you should recalibrate as needed via xarm firmware software.

Docker

Armstone uses persistent docker containers. I.e. there is one docker container that is started/stopped as needed but its the same container. Original build and launch comments for the container are in as_docker

bashrc

  export ROS_IP=192.168.1.101
  export ROS_MASTER_URI=http://192.168.1.101:11311  
  source /opt/ros/melodic/setup.bash  
  echo "CPU MODE:"
  cat /sys/devices/system/cpu/cpu0/cpufreq/scaling_governor  
  #echo performance | sudo tee /sys/devices/system/cpu/cpu*/cpufreq/scaling_governor

JuliusSustarevas / ArmStone