archer sr10plus servo output corrupted
ilioSS53 opened this issue · comments
Hello,
With the version 1.5.0 I wanted to make a new model plane.
Archer sp10plus bind. Ok.
As I was configuring the gyro function stable and level flight mode i started the selftest.
The connected servo,s rotate standstil and where no longer able to move on command from transmitter. Only the channel 3 the throttle is possible to have a esc/servo operational.
I treid almost everything to reinstate the original function of the receiver,
S.a. reset, mede new model etc. Etc, etc. No succes.
It looms like the selftest by moving the servo,s demaged the receiver in one way or the other. My best gues burning the powersupply to the servo,c. But howe about the channel 3?
Very sat it cost my a receiver.
Kind regards, Theo.
Try to do the selfcheck when put the reciever in manual mode， it should work.
Did you also move the sticks at the right time during the self-test?
what made the pins come to life is the last point in your list. switching stabilisation to off.
i guess you forgot to set the limits while self test was on. so the reciever thinks the limits are stick center resulting in no movement range.
happened to me several times. you need to start self test and then move EVERY output channel to its MAX and MIN values.
Usually by moving the sticks and sliders.
after a reciever restart everything should work fine