suite 1.5.0 release: no "refresh" of RF Firmware version after flashing ISRM module
strgaltdel opened this issue · comments
minor suite-bug, only a display problem:
during update to 1.5 release i decided to update my RF module too (X18se)
was on 2.2.2 actual is 2.2.6
Flash process worked as a charme, tx gave a short beep and suite said "finished OK"
But then suite still displayed the old 2.2.2 firmware.
So i flashed manually by tx, same here, update ended with a beep and all seemed to be OK,
Ethos showed 2.2.6
Connected to suite again, suite still displayed 2.2.2, so i was a little bit confused, but convinced the new isrm fw was on tx
several restarts of tx and suite didn't change annything
finally, after rebooting the win notebook and starting of the suite, it displayed the new version, so it seems the info was cached and not refreshed even by restarting suite on a connected transmitter.
seems that it can be replicated:
https://www.rcgroups.com/forums/showpost.php?p=52194017&postcount=1920
regards
udo
As reported by users in "Andreas Engels forum", suite 1.5.3 fixed the issue
so i close it