Inherited Trim Issue
radlouni opened this issue · comments
Hello,
I created an inherited Rudder trim config as follows:
1- First level trim is "Default"
2- Second level is "Offset + Default" tied to switch SC-
3- Third level is "Offset + SC-" tied to switch SC down
first and second level trims operate normally, but third level is erroneous and exhibits a very strange trim values.
I am on latest 1.5.0 version, all is updated to latest version using Ethos Suite
"Offset + SC-"
So you mean Offset -100% since SC is down?
"Offset + SC-" So you mean Offset -100% since SC is down?
No, i mean when configuring the trim, i chose the option "Offset + SC-". This is the exact verbiage in Ethos when configuring inherited trims.
exact steps are:
1- Press Model icon
2- Press "Trims"
3- In rudder trim settings and under Mode, chose "custom"
4- Click on "Add a new behavior"
5- under behavior chose SC- as the switch and "offset+Default" under mode
6- repeat step # 4 and chose SC down as the switch and "Offset + SC-" under mode.
this way, first level trim is when SC switch is up, second level inherited trim is when SC switch is middle, and third level inherited trim is when SC switch is down.
first and second level trims work perfectly, third level trim gives erroneous trim values.
Did anyone have the chance to look at this ?
You are right, something is not working when SC is down
I have found it, stupid copy / paste issue which has not been noticed during RC!