Issue with Cout caps on 12V in BOM?
jwestfall69 opened this issue · comments
Jim Westfall commented
Hi
Thanks for designing this.
The Cout caps in the 12V BOM are listed as being part C2012X7S1A226MAC. However that part is only rated for up to 10V.
Harun Aktas commented
Hello and thank you for your comment. In fact, the capacity operating voltage is not suitable for the 12 volt regulator. I did not realise this either. However, you can use any other MLCC that has the same size and capacitance but with a higher dielectric strength, e.g. 25 volts. I will revise the BOM and correct the error. Thank you very much!