Mislabled header in BBB SRM
sheridp opened this issue · comments
On page 85 of the SRM, when describing how two GPIO pins are connected to the same header pin, the header is incorrectly referred to as P11 (instead of P9).
"# Both of these signals connect to pin 41 of P11."
"@ Both of these signals connect to pin 42 of P11."
While pretty harmless, given that it's contained in section "7.1.2 Connector P9", it did send me checking if there was a P11 on the board.
Thank you for the feedback. Please email Gerald Coley (gerald@beagleboard.org) directly since he is the one who prepares the SRM.
It sent me looking as well. Hope someone emailed the person mentioned above and got it corrected?